-
12月03日
-
D1____________100V 1A Diode bridge
声明:电子发烧友网转载作品均尽可能注明出处,该作品所有人的一切权利均不因本站而转移。
IC3___________7915 15V 1A Negative voltage regulator ICQ1,Q3_________BC337 45V 800mA NPN Transistors
IC1___________LM833 or NE5532 Low noise Dual Op-amp
C2,C3,C4______100΅F 25V ElectrolyTIc Capacitors
Schematic shows left channel and power supply.
SW1___________SPST Mains switch
R4_____________12K 1/4W Resistor
R7______________2K2 1/4W Resistor
D2____________5mm. or 3mm. Red LED
Can drive old 8 Ohms impedance headphones, but these obsolete devices are not recommended.
P1_____________22K Log.PotenTIometer (Dual-gang for stereo)
有趣有料的资讯及技术干货
Output voltage: Well above 5V RMS on all loads
R2,R3__________10K 1/4W Resistors
Frequency response: Flat from 30Hz to 20KHz
C1______________1΅F 63V Polyester Capacitor
Q2,Q4_________BC327 45V 800mA PNP Transistors
R1____________560R 1/4W Resistor
T1____________220V Primary, 15 + 15V Secondary 5VA Mains transformer
R5,R6___________2R2 1/4W Resistor
Technical data:Numbers in parentheses show IC1 right channel pin connections.
C5_____________22pF 63V Polystyrene or Ceramic Capacitor
Amplifier parts:
关键词:耳机放大电路耳机放大器
Can be directly connected to CD players, tuners and tape recorders.
Sensitivity: 250mV input for 5V RMS output
打造属于您的人脉电子圈
Notes:Tested with several headphone models of different impedance: 32, 100, 245, 300, 600 & 2000 Ohms.
R7_____________22R 1/2W ResistorIC2___________7815 15V 1A Positive voltage regulator IC
关注电子发烧友微信
C7,C8________2200΅F 25V ElectrolyTIc Capacitors
关注发烧友课堂
C6_____________22΅F 25V ElectrolyTIc Capacitor耳机放大器电路 (Headphone Amplifier)
锁定最新课程活动及技术直播
Total harmonic distortion @ 1KHz & 10KHz: Below 0.005% on 100 to 2000 Ohms load and up to 5V RMS output (typical 0.003%)Power supply parts:

PL1___________Male Mains plug

Total harmonic distortion @ 1KHz & 10KHz: Below 0.005% on 32 Ohms load and up to 4V RMS output (typical 0.003%)
A correct grounding is very important to eliminate hum and ground loops. Connect in the same point the ground sides of J1, P1, C2, C3 & C4. Then connect separately the input and output grounds at the power supply ground.
Unconditionally stable on capacitive loads
下载发烧友APP
J1______________RCA audio input socket
[导读] 耳机放大器电路 (Headphone Amplifier) Amplifier parts:
,怀旧传奇页游地址:玩怀旧传奇页游就看这里